Skip to content

Configure LAN ports with vSwitches

A vSwitch groups LAN ports on a Service Edge. Configure the LAN network on the switch once; every member port uses that configuration.

flowchart LR
    A[LAN port 1] --> C[vSwitch]
    B[LAN port 2] --> C
    C --> D[LAN addressing, VLANs and DHCP]

Before you start

  • Connect the Service Edge to a Virtual Network.
  • The Service Edge devices must run supported stable software with vSwitch support. If their software is unsupported, a prerelease, or unknown, changes are unavailable. Existing switches remain readable. Contact support if a device needs an update.
  • Choose LAN ports without their own IP configuration and without membership in another vSwitch. WAN ports are not eligible.

Warning

Removing an existing port configuration or moving a port can interrupt connected devices. Review the addressing and DHCP settings before applying the change.

Create a vSwitch

  1. Open Services and select the Service Edge.
  2. In the sidebar, open Interfaces → vSwitch.
  3. Click Create vSwitch and enter a label you recognise.
  4. Save and open the switch from the list.

The switch is linked to this Service Edge and its Virtual Network. You can create more than one switch for separate LAN networks.

Add member ports

  1. Open the switch's Ports section.
  2. Under Available LAN ports, choose a port and click Add to vSwitch.
  3. Repeat for the other ports that should share the network.

A port can belong to only one vSwitch. If it still has its own LAN configuration, remove that configuration first on Interfaces → LAN.

The LAN page identifies member ports and links to their switch. Their separate LAN configuration controls are unavailable because addressing, VLANs, and DHCP belong on the switch.

Configure the LAN network

  1. Open the switch's IP configurations section and add an IP configuration.
  2. Enter a label and a primary IP address with prefix length, for example 192.168.20.1/24.
  3. Add a VLAN ID if the network is tagged.
  4. Choose DHCP Server, DHCP Relay, or No DHCP, and complete the corresponding settings.
  5. Save the configuration.

You can add multiple LAN configurations, for example for multiple VLANs. A switch can have a configuration before any member ports are added. VRRP, secondary IP, and monitor IP are not options for a vSwitch.

Remove a port

In Member ports, click Remove from vSwitch for the port. It becomes available as an ordinary LAN port again. Removing it does not copy the switch's LAN configuration onto that port.

Delete a vSwitch

  1. Return to the switch list and choose Delete for the switch.
  2. Read the confirmation: member ports will be detached and the switch's IP configurations will be deleted.
  3. Confirm only when you intend to remove that shared network.

The physical ports remain available. The deleted switch configuration has no undo.

Apply the changes

Review and apply pending changes through Activity. Follow the workflow and check that connected devices use the intended addressing and VLANs after it completes.